Descrizione
Filament Diameter | 1.75 mm |
Compatible | Zortrax M200/M200Plus/M300/M300 Plus |
Rigid Material | YES |
Flexible Material | YES |
Copertura nozzle in silicone | E’ Motorsil D Rosso, va sosituito ogni volta che si cambia il nozzle.
Necessario solo per stampare filamenti in pla, wood e gomme molto morbide |
It is a new extruder for M200, M300, M200 Plus, M300 Plus
* questo estrusore ha un alta barriera termica ed un blocco alluminio ridotto rispetto all’estrusore originale, quindi i settaggi e le regalazioni dei filamenti saranno diversi (temperature mediamente 20-30°C in meno rispetto all’estrusore originale).
Features:
1. Has half the height of the alu block compared to the original, so it feels better retractions with materials that tend to make stringing as zpetg, zglass, high flexible rubber;
2. Has its own heatsink composed of two throats that help to dissipate and the higher one by touching with the original heatsink transmits more heat to the heatsink itself;
3. The wall of the throat that touches the heat sink creates a greater contact surface also for the passage of the signal during bed leveling, so it will save several platform from drilling;
4. Nozzle M6 compatible with all M6 in the world;
5. Can be installed on M200, M300, M200 Plus, M300 Plus;
6. The smallest alu block allows go fast into heat and keep it better;
7. Compatibily with all kind of Zvent upgrade ventilation system;
8. Alu block reduced;
9. screw block for heater and thermistor
Recensioni
Ancora non ci sono recensioni.